PREPARING FISH ATTRACTOR
Step 1
Take a two liter pop bottle, place the bottle in a hot water for some time until the glue that holds the black base and the label in the place softens. Remove the base with a twisting motion, and peel off the label.
Step 2
By using a hot nail or a drill, burn or drill a dozen or as many holes possible in the sides and bottom of the bottle and few more holes around the bottle neck.
Step 3
Finally drill a hole in the centre of the bottle cap large enough to insert the cord and tie the cord to a small nail, washer, or anything small enough to fit into the inside of the cap. Then screw the cap back onto the bottle and your attractor ring is finally ready to use.
HOW IT WORKS
After getting your bait and once you are on water, fill the bottle with water and put a lot of minnows and screw the cap of the bottle tightly.
Using the cord lower your bottle to the depth you are planning to fish.Lower your baited ring as close as the bottle and watch it out.The minnows in the bottle are like a magnet for attracting fishes, perch etc…

Good trip ill give it a try. Let me add the minnows and see what happens.

I think its mostly used in western countries. Ill try it here for a change.

Its a good one daniel!!!! have you tried it.....I'll try it and will catch you back soon dude...